=================
APP manual
=================

 
* **1**  install nrf mesh app 

* **2**  open nrf mesh app in the red rectangle

     .. image:: img/appmanual_1.png
        :scale: 40%

     
* **3** press “Scanner” button to find your mesh device . All of device will be list on the top 

      .. image:: img/appmanual_2.png
         :scale: 40%
   
* **4** Then select the device just by press the device name , the follow picture will be show 

      .. image:: img/appmanual_3.png
         :scale: 40%         
* **5** after  press the “IDENTIFY”,the button name change to “provision”,and press the  "provision" button to enter provision procdure.

     .. image:: img/appmanual_4.png
        :scale: 40% 
 
* **6** waiting 30s for the phone to provision the device . If the devuce is provisioned successful ,the “OK”  the dialog will be displayed.
     .. image:: img/appmanual_5.png
        :scale: 40%  
  
* **7** config the node , after press “ok” button , the provisioned node will be listed .pls notice the “DISCONNECT” in the corner, it means that the node is    connected . press “CONFIGURE” to bind key for the node.

     .. image:: img/appmanual_6.png
         :scale: 40%     
     
* **8** Follow step is example by our “onoff server”, it have to element, each element have a on-off server model. We only need to config the appkey . press “Element: 001” to config the first element 

     .. image:: img/appmanual_7.png
        :scale: 40%
        
     .. image:: img/appmanual_8.png
        :scale: 40%  
        
* **9** bind appkey: press the “ BIND KEY” and select one appkey to bind.

     .. image:: img/appmanual_9.png
        :scale: 40%
        
     .. image:: img/appmanual_10.png
        :scale: 40%

* **10** Congratulations ! now we can control the light on th board. Slide the window to bottom, press “READ STATE “ to read light current statue , and press “ON” or “OFF “ button to control .

     .. image:: img/appmanual_11.png
        :scale: 40%
        
     .. image:: img/appmanual_12.png
        :scale: 40%
        
=================
Advance Feature:
=================
        
* **11** Subscribe feature config :  Subscribe Addr can be a unicast address or group address . press  the sub button to config .

     .. image:: img/appmanual_13.png
        :scale: 40%
        
* **12**  After  config finished , you can press “ON” or “OFF” to control .

     .. image:: img/appmanual_14.png
        :scale: 40%

        
* **13**  Publish feature allow node to publish status or cmd to notify other node that subscribe the publish address. 

     .. image:: img/appmanual_15.png
        :scale: 40%  

     .. image:: img/appmanual_16.png
        :scale: 40%  

     .. image:: img/appmanual_17.png
        :scale: 40%  

* **14**  you also can config the period  for the publish .

     .. image:: img/appmanual_18.png
        :scale: 40%  

* **15**  press the  “APPLY “ button to let it take effect.. 

     .. image:: img/appmanual_19.png
        :scale: 40%          
\-----------------------------------------------------------