APP manual¶
1 install nrf mesh app
2 open nrf mesh app in the red rectangle
3 press “Scanner” button to find your mesh device . All of device will be list on the top
4 Then select the device just by press the device name , the follow picture will be show
5 after press the “IDENTIFY”,the button name change to “provision”,and press the “provision” button to enter provision procdure.
7 config the node , after press “ok” button , the provisioned node will be listed .pls notice the “DISCONNECT” in the corner, it means that the node is connected . press “CONFIGURE” to bind key for the node.
8 Follow step is example by our “onoff server”, it have to element, each element have a on-off server model. We only need to config the appkey . press “Element: 001” to config the first element
9 bind appkey: press the “ BIND KEY” and select one appkey to bind.
10 Congratulations ! now we can control the light on th board. Slide the window to bottom, press “READ STATE “ to read light current statue , and press “ON” or “OFF “ button to control .
Advance Feature:¶
11 Subscribe feature config : Subscribe Addr can be a unicast address or group address . press the sub button to config .
12 After config finished , you can press “ON” or “OFF” to control .
13 Publish feature allow node to publish status or cmd to notify other node that subscribe the publish address.
14 you also can config the period for the publish .
15 press the “APPLY “ button to let it take effect..
———————————————————–